CompuSTAR CM4200DX Installation Guide

CM4200DX Remote Starter INSTALL GUIDE WWW.COMPUSTAR.COM I. Button Functions

96. After a few seconds you will hear two relay “clicks” and see two parking light flashes and remote coding has been completed. Remote Coding wi

10Number of Parking Light Flashes Tach Error 1 Option 2-10 not in default setting 1 2 Car key in off position 3 No signal or not fast enough ____

11When trying to remote start the vehicle you may experience an error. The siren will chirp and parking lights flash three times followed by a certai

12Lock+Key for 2.5 sec. then Lock+Key for 2.5 sec. Menu 4 2. Selecting the Specific Option Once you select the Option Menu in Step 1 you must scro

13 [III] for a split (0.5) second for optional setting 3 [IV] for a split (0.5) second for optional setting 4 Resetting to Factory De

14To change the option number you wish to program, use the left and right arrow keys on the OP-500, it will scroll through the options available in m

151-7 Unlock / Disarm With Trunk Release Unlock, Factory Disarm, and Trunk Release Factory Disarm, Trunk Release Only Trunk Release Only V V

165 AUX4 output time 1 ~ 100 V V V 6 AUX5 output time 1 ~ 100 V V V 7 AUX6 output time 1 ~ 100 V V V 8 AUX7 output time 1 ~ 100 V V V

17This option setting will set the unlocking/disarming of the control module during the trunk release through the remote. Setting 2 keeps the doors l

184) Option 2-8 (Temp 32°F) on setting 4 5) Set the reservation time at 7 AM (see User’s guide) 6) Turn on Timer Mode on the 2-Way remote. (See Re

CM4200-DX INSTALLATION GUIDE TABLE OF CONTENTS CM4200-DX Wiring Diagram --------------------------------------------

19 3-4 Anti-Grind/Starter-Kill relay With this option on the default setting, the starter-kill relay will act as an anti-grind circuit only. It will

20This option controls the trigger of the Aux output. These are optional event triggers. Default setting triggers Aux 1 by the remote. Setting 2 trig

21TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES ARE EXCLUDED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THE STREAM OF COMMER

2 ________________________________________________________________________________________________ CM4200-DX STARTER CONTROL MODULE This manual is f

3_______________________________________________________________________________________________ DETAILED WIRING GUIDE Important Note: Before you ma

4 starter wire will need to be cut. The yellow wire from pin 87a on the starter interrupt relay will go to the starter side of the vehicles starte

5Pin 7 *White/Black - 2nd Accessory 250mA (-) negative output. This is an optional output that will provide a (-) negative output while the access

6trunk release.) Pin 3 Orange/Black - 2nd Unlock 250mA (-) negative output. This wire is an optional output that will provide a (-) negative puls

7Switch 2 sets the polarity of input for the brown/white key sense or glow plug wire on CN3, Pin 10. This switch also is set in the Option Programmin

86. You will need to first identify what COM port your USB device is set up to use. To do this, Right-click on "My Computer" and go to &