CompuSTAR 1WSS-25 User Manual download pdf (Page 5)

9 By Firstech, LLC By Firstech, LLC 8

Remote Coding / Programming Routine

p@Qb@r

STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the Acc & On positions) five times within 7 seconds. The

vehicle’s parking lights will flash once with the successful completion of this step.

STEP 2: Within a 2 second period after cycling the ignition for the 5th time, pressing the single button once for 0.5 seconds. The parking lights will flash once

to confirm the transmitter has been coded.

Exiting Programming: Programming is a timed sequence. The parking lights will flash twice signaling the end of

programming mode.

Programming Multiple Remotes: After the confirmation flash given in step 2, code additional remotes by pressing

the single button on remote. The parking lights will flash once confirming each additional remote. All systems can

recognize up to three remotes.

IMPORTANT: Every Firstech remote must be coded to the system prior to performing any operations. All remotes must be coded at the same time.

Remote Start Error Diagnostic

If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following those three flashes the parking lights will flash again

corresponding to the error table. AR601-S system only have error codes 1, 2, and 6

We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us directly.

Number of Parking Light Flashes Remote Start Error

Motor running

Key in ignition on position

Door open (manual transmission only)

Trunk open

Foot brake on

Hood open

Reservation off (manual transmission only)

Tach or voltage sensing failure