5 By Firstech, LLC
Quick Reference
When servicing or loaning your vehicle to others, the system should be placed in Valet Mode. Valet Mode prevents the system from remote starting and disables
all alarm functions.
IMPORTANT: While in Valet mode the remote will still control power lock and unlock systems. The parking lights will not flash.
The system can be put into valet one of three ways:
1. Turn the vehicleᴗs key to the ignition ᴘonᴙposition and tap buttons simultaneously for a half second. The parking lights will flash once and/or siren
chirp once to confirm the system is in valet mode. Repeat this process to take the system out of valet mode. The parking lights will flash twice and/or siren chirp
twice to confirm the system is out of valet mode.
2. If you do not have your remote control, you can put the system into valet by turning the ignition key ᴘonᴙand then ᴘoffᴙfive times within 7 seconds. The
parking lights will flash once to confirm the system is in valet mode. Shortly after the first flash, the parking lights will flash twice. A remote control is required to
take the system out of valet mode.
3. If your system is set up for a secure valet option (optional), you will not be able to put the system into valet until the proper code has been entered using the
secure valet switch. The secure valet switch is the small button with bright blue LED on the front and if installed is the only way to override the alarm and/or
remote start. Until programmed, the default code is (3, 3).
v@m
By Firstech, LLC 6
Quick Reference
When the battery on your 2 Way remote is low, you will no longer receive 2 Way confirmation in areas you usually do. Your remote will only send commands to
your vehicle. The Lock LED on your 2 Way remote will flash red and/or fade after transmission. The only regular maintenance this system requires is remote
control battery replacement. No programming is required when replacing the battery.
Two Way Remotes:
Turn the remote over and gently grip the remote. Use your thumb to slide the lower cover down, revealing the battery. Your battery size should be listed on the
battery. (Battery size: CR2450) IMPORTANT: Be sure to observe correct polarity when installing the battery.
One Way Remotes:
First, remove the small Phillips screw located on the back of the remote. Once the screw has been removed, gently pull the remote apart taking care to not damage
the circuit board. Your battery size should be listed on the battery. Replacements can be purchased from your local Firstech dealer or an electronics store.
r@mMb@r
(9 pages)
(14 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals